@Con-Hennekens ik had alle poi’s nog even gecontroleerd en netjes op de wegen gezet. Wanneer ik nu de route open, en een poi aan klik, dan verschijnt er een blauw balkje alsof er iets geladen wordt. Daarna niets. Hou ik datzelfde punt na de vorige actie langer ingedrukt, dan verschijnt er wel een route.

@Guus-Jager the icon in the upper left corner indicates that the app is attempting to recalculate your route. If it is there for a long time it can be an caused by a poor Internet connection. Different things may happen depending on if you have downloaded loaded maps. I have also seen this when leaving home and my WiFi connection gets out of range. With downloaded maps it can switch to offline operation.

I fixed this on my own. I flashed new firmware and on the audio setting made sure the unit sent everything to the phone. All instructions now go from phone to headset.

@Con-Hennekens Thanks Con, Yes I should have noticed that!

@richtea999 Thanks! But 'unfortunatelly' it was already on car-modus...
Nevertheless, I will keep an extra eye open for this setting it it occurs again.

@superg said in Track wil enkel bij beginpunt beginnen??:

daarom sla ik altijd alles op als ROUTE met veel punten

Ook dat is onnodig... je moet net zoveel punten gebruiken als noodzakelijk om jouw route precies te volgen. Op een weg van 100km lang zonder afslagen heb je echt niet meer dan 1 routepunt nodig! En omdat je de route op de website maakt in de zelfde kaart als waarmee je in de app navigeert, zal je de route die je hebt gemaakt feilloos kunnen volgen.

De routeplanner en het navigatiedeel van de website maken beiden gebruik van de Here-kaart. Als je een abonnement hebt op de navigatiemodule kan je in de website ook de Here-kaart gebruiken om routes te plannen.

@Con-Hennekens It was moving off the Android Auto screen but may have also been doing it on the Phone but I was unable to check while I was driving (and I was driving my wife nuts asking her to keep checking the status on the phone and AA car display!)

@Nigel-Ralphson, If you plan your route on the HERE map, differences while navigating can virtually only happen due to traffic. So if you did not encounter any traffic problems, it is a sign that you probably did not plan it on the HERE map, and that you have set way too less waypoints. You may share that route with us, so we can have a look. Without that, I don't see how we can be of further assistance.

@Mzokk Wireless

@Con-Hennekens Hi Con
thanks for your patience and approval of my route.
I got him to create his own short route and it stated "could not calculate route" even though he is online and in any case has downloaded the countries for offline.

You could try using Carpe Iter and Carpe Iter (Old) configuration.
I actively tested the adventure controller before the last update so there might be mismatch in firmware?

Could you let me know what what keycodes the individual buttons trigger? You can use a tool like this https://jaxeadv.com/barbuttons/keypress-tester/

You can also cancel the upload and then force it again to upload it.
Simply click the shown icons 😉

@George-12 No, wokrs all fine. Try to force close the app and than open the app and route again. If that don't work, try to install the app from scratch.

@Shawn-Graham said in POI TURN BY TURN:

@Con-Hennekens yes, but that does not show me turn by turn list of directions

Ah, it is a roadbook you are after... Most of us were thinking something did not work. A elaborate question would have prevented more than half of the replies in this thread. But as you by now will have discovered, MRA Navigation does not offer a live roadbook function. To be honest, I don't think many users would use it if they did.

@Kenny-Thierens Hi Kenny - no, not really. it is just about useable but the volume is maxed-out. I'm off to Europe later this week so will find out what it's like on long motorway trips. I've not heard back from the MRA team after an initial reply after logging a support call.

@Peter-Schiefer Thanks Peter! Just reported.

@Corjan-Meijerink, it might be a good idea make these functions equal in planner and app 😉

Thank you, Nick.

I spotted it just as you replied.

I missed point 15 when checking the other 73 points, several of which I had moved for exactly the reason you gave.

All is well now.

Richard

@Nick-Carthew excellent news roundabout instructions are working! Wish I messaged on day 1! I've been struggling. On day 7 now heading home just went past Glasgow (anti-clockwise). We actually did the NC767 extended NC500 from MCN.

More of a sight seeing trip which isn't my thing I prefer fast winding roads. But I can say I've done it.

Weather was pretty good some rain, hail and blustery wind low of 5 degrees.

Thanks for your help.

@AlexvLeeuwen said in Vragen en bijzonderheden:

Waar ik ook achter kwam is dat de fout met de here kaart er nog in zit, iedere rotonde eerste afslag

Wat @Rob-Verhoeff hierover zegt klopt helemaal, maar ik meen begrepen te hebben dat dit inmiddels is opgelost. Echter afhankelijk van de versie van het off-line kaartmateriaal kan het nodig zijn om die te updaten.

iedere keer als je een route inlaad moet je er rekening mee houden snelweg en onverhard uit te zetten

Bij het maken van een nieuwe route in de planner klopt dat. Bij het inladen van die route in je MRA Navigatie klopt dat eigenlijk niet. De instellingen van de planner worden vanzelf meegenomen. Bij het genereren van een nieuwe route in de app zelf eigenlijk ook niet. Bij het gebruik van de kronkelroute-opties worden stadscentra en snelwegen ook vermeden als je dat niet expliciet uit zet.