Suggestion: don't consider shaping waypoints to be "destinations" in PDF export
-
When I export a route to PDF, each waypoint currently gets 3 lines in the instructions saying:
- "Turn left onto XYZRoad. Go for x km", where x is the distance from the turn to the waypoint.
- "Arrive at XYZRoad. [Your destination is on the right]". The last part of this line isn't always there.
- "Head [toward SomeRoad|direction] on XYZRoad. Go for y km", where y is the distance from the waypoint to the next turn.
Especially since the introduction of via-points, this is superfluous and even somewhat annoying for shaping points, as they are not intended to be used as destinations at all.
Ideally, these 3 lines should be replaced by just a single line for shaping points. From the example above this would be: "Turn left onto XYZRoad. Go for x+y km.", basically treating the shaping point as if it wasn't there (which is what nav systems do).
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login-
1110100
-
07125
-
0736
-
0459
-
1688
-
0326
-
0368
-
0333
