Studio 0.2.0 on Mac: export stays at 0% and Cancel does not close it

[Gordon Hodges]

I have been testing Studio 0.2.0 on my Mac on 30 October, using a private disposable planned Moto route rather than a recorded ride. Loading the route, preview playback and saving/reopening the project all worked well. The automatic twisty highlights look promising for introducing a tour to fellow riders.

The route has 150 waypoints and is about 95 miles. I selected the 30-second flyover preset; the Output timeline showed 1 minute 6 seconds with eight highlights. No photos, video clips or audio were added.

I tried a local 16:9 export at 1080p/30 fps with Full performance. It remained at 0% for approximately two minutes, and clicking Cancel export did not dismiss the export screen. After quitting and reopening Studio, the saved project restored correctly. I then tried Quick share at 540p/24 fps, again with Full performance, and saw the same behaviour for approximately two minutes. Neither attempt produced a completed video in the selected folder.

I have read the existing “MRA Studio export speed” topic and Jörgen’s encouraging results with 0.2.0. I am not sure whether my result is related. Is an initial preparation period at 0% expected for this sort of planned route, or is there a setting or diagnostic check I should try next? I have retained the project and a screenshot if useful.

[Corjan Meijerink]

Can you Slack me the logs from Studio?
You can get these from the account dropdown top right.